The lux (symbol: lx) is the SI unit of illuminance and luminous emittance, measuring luminous flux per unit area. It is used in photometry as a measure of the intensity, as perceived by the human eye, of light that hits or passes through a surface. It is analogous to the radiometric unit watts per square metre, but with the power at each wavelength weighted according to the luminosity function, a standardized model of human visual brightness perception. In English, "lux" is used in both singular and plural.[1]
Contents |
Illuminance is a measure of how much luminous flux is spread over a given area. One can think of luminous flux (measured in lumens) as a measure of the total "amount" of visible light present, and the illuminance as a measure of the intensity of illumination on a surface. A given amount of light will illuminate a surface more dimly if it is spread over a larger area, so illuminance is inversely proportional to area.
One lux is equal to one lumen per square metre:
A flux of 1,000 lumens, concentrated into an area of one square metre, lights up that square metre with an illuminance of 1,000 lux. However, the same 1,000 lumens, spread out over ten square metres, produces a dimmer illuminance of only 100 lux.
Achieving an illuminance of 500 lux might be possible in a home kitchen with a single fluorescent light fixture with an output of 12,000 lumens. To light a factory floor with dozens of times the area of the kitchen would require dozens of such fixtures. Thus, lighting a larger area to the same level of lux requires a greater number of lumens.
As with other SI units, SI prefixes can be used, for example a kilolux (klx) is 1,000 lux.
| Illuminance | Example |
|---|---|
| 10−4 lux | Total starlight, overcast sky[2] |
| 0.002 lux | Moonless clear night sky with airglow[2] |
| 0.01 lux | Quarter moon |
| 0.27 lux | Full moon on a clear night[2][3] |
| 1 lux | Full moon overhead at tropical latitudes[4] |
| 3.4 lux | Dark limit of civil twilight under a clear sky[5] |
| 50 lux | Family living room (Australia, 1998)[6] |
| 80 lux | Hallway/toilet in office buildings[7][8] |
| 100 lux | Very dark overcast day[2] |
| 320–500 lux | Office lighting[9][10][11] |
| 400 lux | Sunrise or sunset on a clear day. |
| 1,000 lux | Overcast day;[2] typical TV studio lighting |
| 10,000–25,000 lux | Full daylight (not direct sun)[2] |
| 32,000–130,000 lux | Direct sunlight |
Unicode has a symbol for "lx": (㏓). It is a legacy code to accommodate old code pages in some Asian languages. Use of this code is not recommended.
Like all photometric units, the lux has a corresponding "radiometric" unit. The difference between any photometric unit and its corresponding radiometric unit is that radiometric units are based on physical power, with all wavelengths being weighted equally, while photometric units take into account the fact that the human eye's visual system is more sensitive to some wavelengths than others, and accordingly every wavelength is given a different weight. The weighting factor is known as the luminosity function.
The lux is one lumen per square metre (lm/m2), and the corresponding radiometric unit, which measures irradiance, is the watt per square metre (W/m2). There is no single conversion factor between lx and W/m2; there is a different conversion factor for every wavelength, and it is not possible to make a conversion unless one knows the spectral composition of the light.
The peak of the luminosity function is at 555 nm (green); the eye's visual system is more sensitive to light of this wavelength than any other. For monochromatic light of this wavelength, the irradiance needed to make one lux is minimum, at 1.464 mW/m2. That is, one obtains 683.002 lux per W/m2 (or lumens per watt) at this wavelength. Other wavelengths of visible light produce fewer lumens per watt. The luminosity function falls to zero for wavelengths outside the visible spectrum.
For a light source with mixed wavelengths, the number of lumens per watt can be calculated by means of the luminosity function. In order to appear reasonably "white," a light source cannot consist solely of the green light to which the eye's visual photoreceptors are most sensitive, but must include a generous mixture of red and blue wavelengths to which they are much less sensitive.
This means that white (or whitish) light sources produce far fewer lumens per watt than the theoretical maximum of 683 lumens per watt. The ratio between the actual number of lumens per watt and the theoretical maximum is expressed as a percentage known as the luminous efficiency. For example, a typical incandescent light bulb has a luminous efficiency of only about 2%.
In reality, individual eyes vary slightly in their luminosity functions. However, photometric units are precisely defined and precisely measurable. They are based on an agreed-upon standard luminosity function which is based on measurements of the spectral characteristics of visual photoreception in many individual human eyes.
Specifications for video cameras such as camcorders and surveillance cameras often include a minimum illuminance level in lux at which the camera will record a satisfactory image. A camera with good low-light capability will have a lower lux rating. Still cameras do not use such a specification, since longer exposure times can generally be used to make pictures at very low illuminance levels, as opposed to the case in video cameras where a maximum exposure time is generally set by the frame rate.
The corresponding unit in English and American traditional units is the foot-candle. One foot candle is about 10.764 lux. Since one foot-candle is the illuminance cast on a surface by a one-candela source one foot away., a lux could be thought of as a "metre-candle", although this term is discouraged because it does not conform to SI standards for unit names.
One phot (ph) equals 10 kilolux.
One nox (nx) equals 1 millilux.
| Quantity | Symbol[nb 1] | SI unit | Symbol | Dimension | Notes | |||
|---|---|---|---|---|---|---|---|---|
| Luminous energy | Qv [nb 2] | lumen second | lm⋅s | T⋅J | units are sometimes called talbots | |||
| Luminous flux | Φv [nb 2] | lumen (= cd⋅sr) | lm | J | also called luminous power | |||
| Luminous intensity | Iv | candela (= lm/sr) | cd | J [nb 3] | an SI base unit, luminous flux per unit solid angle | |||
| Luminance | Lv | candela per square metre | cd/m2 | L−2⋅J | units are sometimes called nits | |||
| Illuminance | Ev | lux (= lm/m2) | lx | L−2⋅J | used for light incident on a surface | |||
| Luminous emittance | Mv | lux (= lm/m2) | lx | L−2⋅J | used for light emitted from a surface | |||
| Luminous exposure | Hv | lux second | lx⋅s | L−2⋅T⋅J | ||||
| Luminous energy density | ωv | lumen second per metre3 | lm⋅s⋅m−3 | L−3⋅T⋅J | ||||
| Luminous efficacy | η [nb 2] | lumen per watt | lm/W | M−1⋅L−2⋅T3⋅J | ratio of luminous flux to radiant flux | |||
| Luminous efficiency | V | 1 | also called luminous coefficient | |||||
| See also: SI · Photometry · Radiometry | ||||||||
|
||||||||||||||||||||